Lauda IN 130 T Operation Manual page 113

Editing a program
Add new segment
Fig. 66: Select program segment
Delete segment
V6
Please note:
If in the hh and :mm field the value "0" is entered, the temperature T
n
will be started as quickly as possible.
Changes to the pump level are entered in the respective segment (=
n
program line).
The default value of the contact module is off .
n
You have the following options in the selected program:
By pressing the right arrow key 5 times you can display the columns
n
Pump, S1, S2 and S3 of the program.
Use the left arrow key to display the columns Tend, hh, :mm and Toler-
n
ance again.
With the [up] and [down] arrow keys, you can navigate to the segments
n
(lines) of a program.
With the [OK] you select a value for editing.
n
Use the [right] and [left] arrow keys to select individual digits of the
n
value.
With the [up] and [down] arrow keys, you can increase or reduce the
n
selected digit.
With the [ESC] softkey, you can deselect a selected value again.
n
With the [OK] key, you confirm your change.
n
You exit the program with the [ESC] softkey. The entered values are
n
saved.
1. Navigate to the segment under which the new segment should be
added.
2. In this segment, navigate to the column with the No.
3. Press the [NEW] key.

1. Navigate to the segment that you want to delete.
2. In this segment, navigate to the column with the No.
3. Press the DELETE softkey.

Integral Process Thermostats and High-Temperature Thermostats
A new segment is created.
The segment is deleted.
end
113 / 198