Lauda IN 130 T Operation Manual page 59

ID Function
28 Limitation of outflow temperature TiH (lower limit)
32 Temperature set point T
Table 24: Pump
ID Function
17 Pump power stage 1 – 8
(only for Integral XT)
30 Set pressure (for pressure control settings)
(only for Integral XT)
36 Through-flow control set point
70 Activate through-flow control: 0=Switch = switch off / 1 = switch on [–]
155 Pressure limitation set point with active through-flow control
(MID flow controller must be connected and equipped with an inte-
grated pressure sensor)
159 Actual value of external pressure control variable (via interface)
163 Pressure measurement value source
Table 25: Cooling
ID Function
23 Cooling mode: 0 = off / 1 = on / 2 = automatic
Table 26: Safety
ID Function
34 Timeout communication via interface (1 – 60 seconds; 0 = Off)
72 Activate Safe Mode
Table 27: Control parameters
ID Function
38 Control parameter Xp
40 Control parameter Tn (5 – 180 s; 181 = Off)
42 Control parameter Tv
44 Control parameter Td
46 Control parameter KpE
48 Control parameter TnE (0 – 9000 s; 9001 = Off)
50 Control parameter TvE (5 = Off)
V6
in Safe Mode
set
Integral Process Thermostats and High-Temperature Thermostats
Unit Command
[°C] OUT_SP_05_XXX
[°C] OUT_SP_07_XXX.XX
Unit Command
[–] OUT_SP_01_XXX
[bar] OUT_SP_06_X.XX
[l/min] OUT_SP_09_X.XX
OUT_MODE_05_X
[bar] OUT_SP_10_X.X
[bar] OUT_PV_06_XX.XX
[--] OUT_MODE_07_[value]
Unit Command
[–] OUT_SP_02_XXX
Unit Command
[s] OUT_SP_08_XX
[–] OUT_MODE_06_1
Unit Command
[–] OUT_PAR_00_XX.X
[s] OUT_PAR_01_XXX
[s] OUT_PAR_02_XXX
[s] OUT_PAR_03_XX.X
[–] OUT_PAR_04_XX.XX
[s] OUT_PAR_05_XXXX
[s] OUT_PAR_06_XXXX
59 / 198