Operate The Device Using The Command Touch Unit; Setting Heat Transfer Liquid - Lauda IN 130 T Operation Manual

5.3.4 Operate the device using the Command Touch unit

5.4

Setting heat transfer liquid

V6
[Temperature scale]: automatic or manual.
n
Here you can define which temperature range is displayed in the visible
graph window.


[Temperatutre limits]: T.scale Min and T.scale Max.
n
Here you can manually define which time range is displayed in the visible
graph window.
The device can also be operated with the Command Touch remote control
unit (accessory).
The following information is only relevant for the Integral T device:
The following information is only relevant for the Integral XT device:
Integral Process Thermostats and High-Temperature Thermostats
[Autom.]: The size of the visible graphic area automatically adapts to
the changing temperature curves.
If the setting is selected automatically, the following menu item
(Temperature limits) is not visible.
WARNING!
Device start carried out from remote control unit
Scalding, cold burns
Switch the local operating unit into standby

WARNING!
Overheating of heat transfer liquid due to incorrect entry of
overtemperature switch-off point T
Fire
Set the overtemperature switch-off point for the hydraulic

circuit to 5 K above the upper limit of the temperature
range for your application. But not above the upper limit of
the working temperature range of the heat transfer liquid.
WARNING!
Overheating of heat transfer liquid due to incorrect entry of
overtemperature switch-off point T
Fire
In the menu of the device, set the heat transfer liquid used

in the device. Set the overtemperature switch-off point
below the flash point of the heat transfer liquid.
for the hydraulic circuit
max
for the hydraulic circuit
max
69 / 198