Wiring Harness, Battery; Changing The Main Fuse; Removing The Battery - Husqvarna FS 450 2015 Repair Manual

Table of Contents

Advertisement

15

WIRING HARNESS, BATTERY

Changing the main fuse

Warning
Fire hazard
Incorrect fuses overload the electrical system.
-
Only use fuses with the required ampere value.
-
Do not bypass or repair fuses.
Info
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid.
Removin the batte
Warning
Risk of injury
Battery acid and battery gases cause serious chemical burns.
-
Keep batteries out of the reach of children.
-
Wear suitable protective clothing and goggles.
-
Avoid contact with battery acid and battery gases.
-
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
-
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at
least 15 minutes and contact a physician.
Preparatory work
-
Switch off all power consumers and switch off the engine.
-
Remove the air filter box lid.
Main work
-
Take off protection caps
-
Remove the faulty main fuse @.
Info
I
A defective fuse can be identified by the burned-out fuse wire
8
A spare fuse
is located in the starter relay.
-
Install a new main fuse.
I
Fuse (58011109110)
(!i.,!I
-
Check that the electrical equipment is functioning properly.
Tip
I
Insert the spare fuse so that it is available if needed.
-
Mount the protection caps.
Finishing work
-
Install the air filter box lid.
Preparatory work
-
Switch off all power consumers and switch off the engine.
-
Remove the seat.
(!i.,!I
p. 80)
(a
p. 77)
O.
p. 208)
(�
p. 77)
106
e.

Advertisement

Table of Contents
loading

Table of Contents