Table of Contents
Advertisement
6
FORK, TRIPLE CLAMP
6.31
Adjusting the steering head bearing Qla}!
-
Remove the upper bearing race @ using a suitable tool.
-
Press in the new bearing race all the way using a suitable tool.
-
Pull off bearing@.
Remove seal ring retainer.
-
Remove O-ring.
-
Grease the new O-ring and mount with seal ring retainer.
-
Press on the new bearing with a suitable tube as far as it will go.
G01808-10
Finishing work
-
Install the lower triple clamp.
-
Mount the handlebar cushion.
-
Install the front fender.
-
Install the start number plate.
-
Install the front wheel.
-
Check that the wiring harness, throttle cables, and brake and clutch lines can
move freely and are routed correctly.
-
Check the steering head bearing play.
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the handlebar cushion.
Main work
Loosen screws
-
Remove screw
-
Loosen and retighten screw
I
Guideline
Screw, top steering head
-
Using a plastic hammer, tap lightly on the upper triple clamp to avoid stresses.
-
Mount and tighten screw@.
Guideline
Screw, top steering stem
(a
p. 37)
(a
p. 90)
(�
p. 90)
(�
p. 94)
(I!:!
p. 39)
(I!:!
(�
p. 10)
O.
8.
8.
I
M20x1.5
M8
p. 10)
12 Nm (8.9 lbf ft)
17 Nm
Loctite
®
243
(12.5 lbf ft)
40
™
Advertisement
Table of Contents
