Husqvarna FS 450 2015 Repair Manual page 40

6
FORK, TRIPLE CLAMP
-
Position the fork legs.
(D
✓ Bleeder screws
• Info
I
Grooves are milled into the side of the upper end of the fork legs. The sec­
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
-
Tighten screws @.
Guideline
I
Screw, bottom triple clamp
C,.
Tighten screw
Guideline
I
Screw, top steering head
-
Mount and tighten screw@.
Guideline
Screw, top steering stem
-
Using a plastic hammer, tap lightly on the upper triple clamp to avoid stresses.
0.
-
Tighten screws
Guideline
I
Screw, top triple clamp
-
Position brake line and bracket on fork protector, and mount and tighten screws.
Finishing work
-
Mount the handlebar cushion.
-
Install the front fender. (a
-
Install the start number plate.
-
Install the front wheel. (!,JI
-
Check that the wiring harness, throttle cables, and brake and clutch lines can
move freely and are routed correctly.
-
Check the steering head bearing play.
-
Remove the motorcycle from the lift stand.
are positioned toward the front.
I
M20x1.5
1 7 Nm
MB
(12.5 lbf ft)
p. 90)
(!,JI p. 90)
p. 94)
(I!!:! p. 39)
(I!!:! p. 10)
38
1 12 Nm (8.9 lbf ft)
12 Nm (8.9 lbf ft)
Loctite 243
® ™
I
1 1 7 Nm (12.5 lbf ft)