Installing The Clutch Cover - Husqvarna FS 450 2015 Repair Manual

17 ENGINE
17.5.17

Installing the clutch cover

8.
-
Insert pressure piece
Set the crankshaft to top dead center and lock it with special tool
I
Locking screw (113080802)
-
Position pressure cap (D.
Mount and tighten screws @ with the spring retainers and clutch springs.
Guideline
I
Screw, clutch spring retainer
-
Remove special tool (D.
I
Assembly screws (75029033000) (!!;!Ip. 231)
-
Position the balancer shaft with special tool
I
Fixing drift (78129032000)
O
✓ Marking and the special tool are aligned.
-
Mount dowels@ and position the clutch cover gasket@).
-
Mount the clutch cover.
8
-
Mount screws but do not tighten them yet.
Guideline
I
Screw, clutch cover
Mount screw Ci) but do not tighten yet.
Guideline
I
Screw, clutch cover
(� p. 227)
O.
(� p. 234)
I
M6x25
I
M6x55
178
@).
I 6 Nm (4.4 lbf ft)
110 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)