Table of Contents
Advertisement
20
LUBRICATION SYSTEM
-
Place the long oil screen
-
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
-
Push the oil screen all the way into the engine case.
-
Mount and tighten screw plug
Guideline
I
Screw plug, oil screen
-
Mount and tighten oil drain plug
Guideline
I
Oil drain plug with magnet
0-
-
Remove screws
Remove the oil filter cover with the O-ring.
-
Pull oil filter (3 out of the oil filter housing.
I
Circlip pliers reverse (51012011000)
-
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing area.
-
Lay the motorcycle on its side and fill the oil filter housing to about ½ full with
engine oil.
-
Insert the oil filter into the oil filter housing.
-
Lubricate the O-ring of the oil filter cover and mount it with the oil filter cover @.
-
Mount and tighten the screws.
Guideline
I
Screw, oil filter cover
-
Stand the motorcycle upright.
@)
-
Remove filler plug
and the O-ring from the clutch cover and fill up with engine
oil.
I
Engine oil
11 .50 I (1 .59 qt.)
•
Info
I
Too little engine oil or poor-quality engine oil results in premature wear of
the engine.
-
Install and tighten the oil filler plug with O-ring.
8
with the O-rings onto a pin wrench.
(D
with the O-ring.
I
M20x1 .5
O
with the magnet and a new seal ring.
I
M12x1.5
(a
p. 228)
I
Engine oil (SAE 1 0W/50)
197
I
115 Nm (11.1 lbf ft)
I
I
20 Nm (14.8 lbf ft)
I 6 Nm (4.4 lbf ft)
(fll:!l
p. 222)
Advertisement
Table of Contents
