Husqvarna FS 450 2015 Repair Manual page 26

6
FORK, TRIPLE CLAMP
�
Measure the outside diameter of the inner tube at several locations.
Outside diameter of the inner tube
If the measured value is less than the specified value:
-
Measure the run-out of the inner tube.
I
Inner tube run-out
If the measured value is greater than the specified value:
-
200685-10
Measure the inside diameter of the outer tube at several locations.
I
Inside diameter of the outer tube
the measured value is greater than the specified value:
If
-
Check the outer tube for damage.
there is damage:
If
-
Check the surface of the sliding bushing.
If the bronze-colored layer
face is rough:
e
200665-10
Check the spring length.
I Guideline
Spring length with preload spacer(s)
the measured value is greater than the specified value:
If
the measured value is less than the specified value:
If
200666-10
Check the check valve spring length.
Guideline
I
Spring length of the check valve
If the measured value is less than the specified value:
-
200892-10
Change the inner tube.
Change the inner tube.
Change the outer tube.
Change the outer tube.
G
under the sliding layer
Replace the sliding bushing.
Reduce the thickness of the preload spacers.
Increase the thickness of the preload spacers.
Change the spring.
47.975 ... 48.005 mm (1.88878 ...
1.88996 in)
I
$ 0.20 mm ($ 0.0079 in)
I
$ 49.20 mm ($ 1.937 in)
Ce,
is visible or the sur­
I
482 mm (18.98 in)
I �
5.8 mm (� 0.228 in)
24