Table of Contents
Advertisement
18
CLUTCH
-
Remove screw
•
Info
I
Never remove more than one screw at once.
-
Position the required washer.
Guideline
Low preload, without washer
Moderate preload, with washer (con-
dition at delivery)
High preload, with washer
-
Mount and tighten screw
Guideline
I
Screw, clutch spring retainer
-
Repeat the procedure with screws (D, @, and @.
•
Info
I
The spring preload must b e the same on all screws.
S00608-10
-
Check O-ring
I f the O-ring is damaged:
-
Change the O-ring.
-
Lub ricate the O-ring with engine oil and position the clutch cover.
-
Mount screws
Guideline
I
Screw, clutch cover
-
Mount screw
Guideline
I
Screw, clutch cover
-
Mount screw
Guideline
I
Screw, clutch cover
-
Tighten all screws in a crisscross pattern.
Guideline
I
Screw, clutch cover
-
Attach spring
Finishing work
m
-
Stand the motorcycle upright.
Danger
Danger of poisoning
result in unconsciousness and death.
-
Always make sure there is su f ficient ventilation when running the
engine.
-
Use an e f fective exhaust extraction system when starting or running
the engine in an enclosed space.
-
Start the engine and check that it is oil-tight.
-
Check the engine oil level.
0.
1.0 mm (0.039 in)
1.5 mm (0.059 in)
C,.
I
@)
for damage.
8
b ut do not tighten yet.
I
8
b ut do not tighten yet.
I
8
b ut do not tighten yet.
I
0-
Exhaust gases are toxic and inhaling them may
(�
p. 195)
0 mm (0 in)
M5
I 8 Nm (5.9 lbf ft)
M6x25
10 Nm (7.4 lbfft)
M6x55
10 Nm (7.4 lbf ft)
M6x60
10 Nm (7.4 lbfft)
I10Nm(7.41bfft)
191
Advertisement
Table of Contents
