Table of Contents
Advertisement
16
BRAKE SYSTEM
-4!)
�-----309386-10
-
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
-
Cover the painted parts.
O.
-
Remove screws
8
-
Remove cover
with the membrane.
-
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill
with fresh brake fluid.
Bleed syringe (50329050000)
Brake fluid DOT 4
(ll!ll
p. 222)
8.
-
Mount bleeder cover
I
Bleeder cover (00029013002)
-
Connect the bleeding device.
I
Bleeding device (00029013100)
C,.
-
Open shut-off valve
•
Info
I
Follow the operating instructions of the bleeding device.
-
Ensure that the filling pressure is set on pressure gauge f). Adjust the filling
pressure on pressure regulator
I
Guideline
Filling pressure
0
-
Pull off protection cap
of the bleeder bottle.
I
Bleeding device (00029013100)
-
Open bleeder screw (3 by approx. one-half turn.
•
Info
I
Drain until the fresh brake fluid emerges from the hose of the bleeder bot
tle without bubbles.
-
Tighten the bleeder screw.
C,.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerging.
•
Info
I
This prevents overfilling of the brake fluid reservoir.
-
Tighten the bleeder screw. Remove the hose of the bleeder bottle. Mount the pro
tection cap.
-
Lock the bleeding device. Remove the bleeder cover.
-
Add brake fluid to level (9.
Guideline
0
Level
(brake fluid level below con-
tainer rim)
I
Brake fluid DOT 4
(ll!ll
p. 222)
-
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
(ll!ll
p. 228)
(ll!ll
p. 226)
(ra:!l
p. 226)
0
if necessary.
1
2 ... 2.5 bar (29 ... 36 psi)
of the brake caliper bleeder screw. Connect the hose
(8
p. 226)
5 mm (0.2 in)
115
Advertisement
Table of Contents
