Table of Contents
Advertisement
SHOCK ABSORBER, SWINGARM
9
•
9.25
Filling the dam er with nitrogen
-
When the pressure gauge reaches the specified value, turn the
trol lever to
Vacuum.
Guideline
3 bar
✓ The pressure gauge drops to the specified value.
0 bar
-
When the pressure gauge reaches the specified value, operate the
Guideline
0 bar
✓ The vacuum pump is switched off.
-
Slide O-ring
minus specified value).
Guideline
10 mm
I
Depth micrometer (T107S)
-
Slide the floating piston into the reservoir to the shortened position using the spe
cial tool.
•
Info
I
The floating piston must be positioned at exactly this point when the rod
is fully extended; otherwise, damage will occur during compression of the
shock absorber.
-
Remove the special tool.
-
Remove adapter
•
Info
I
Hold the damper so that the filling port is at the highest point.
-
Remove the adapter.
-
Mount and tighten screw@).
Guideline
I
Screw, filling port
-
Screw in screw
Info
The piston rod is fully extended.
201396-10
-
Clamp the special tool in the vise.
I
Nitrogen filling tool (T170S1)
-
Connect the special tool to the pressure regulator of the filling cylinder.
I
Filling gas - nitrogen
-
Adjust the pressure regulator.
Guideline
I
Gas pressure
201397-10
-
Position the damper in the special tool.
✓ The hexagonal part of the tap handle
the filling port screw.
to the end of the special tool by the specified value (distance
4)
(�
p. 231)
O
from connection @ of the vacuum pump.
I
O
by approx. 2 rotations but do not tighten.
(�
p. 234)
I
Damper
On/Off
M10x1
14 Nm (10.3 lbf ft)
1
10 bar (145 psi)
O
engages in the hexagon socket of
60
8
con
switch.
0
I
Advertisement
Table of Contents
