Main Monitor - Idis DR-8300 Series Operation Manual

Part 2 - Configuration
● Text-In / ANPR: Displays data received from text-in
and ANPR devices. Select Display Dwell and specify
how long to display data. Data are shown on the
single screen only.
● Resolution (Search): Displays the recording
resolution in Playback mode.
● Codec (Search): Displays the codec information in
Playback mode.
● Zoom: Displays a zoomed in state.
● Freeze & Sequence: Displays freeze and sequence
icons.
● Screen Group: Displays the current screen's group.
104

Main Monitor

Configure monitor-related settings.
● Mode: Select Full Sequence or Cameo Sequence.
● Interval: Select between 3 secs and 2 mins. For more
information on Sequence, refer to the 8 Sequence on
page 25.
● Manual Configuration: Set the resolution manually
regardless of the resolution supported by the monitor.
● Resolution: Select from 3840 x 2160, 1920 x 1200,
1920 x 1080, 1680 x 1050 and 1600 x 1200.
● Event Monitoring On: With Event Monitering
enabled, the camera screen linking event monitoring
is shown. For more information on Event Monitoring,
refer to the NVR Failover_Registration on page
29.
● Event Alert: With Event Alert selected, the red line
appears on the top of the camera screen linking event
monitoring when an event occurs.
• Supported resolutions may be restricted
depending on the monitor.
• 3840 x 2160 @ 50/60Hz resolution is supported
only in HDMI 2.0 monitor.
• We recommend using 3840 x 2160 or 1920 x 1080
resolution.
• If you use a VGA monitor as the main display, we
recommend that you use a resolution of 1920 x
1080 or below.
• HDMI deep color feature is not supported.
● Use BRP(Boost Remote Performance) mode : With
BRP mode on, the camera full screen does not display
in live mode and the network bandwidth can limit to
500Mbps.
● Priority : Select the camera's live stream priority,
either resolution or frame rate.