Idis DR-8300 Series Operation Manual page 51

– Dwell Time (sec.): Specify how long the camera will
dwell at start and stop positions.
– Speed/Direction: Specify scanning speed and
direction.
● Test: Select a scan profile and then click Test to test it.
● Edit: Used to edit the selected scan profile.
● Remove: Used to remove the selected scan profile.
3 Pattern
Used to set up a pattern profile for the camera to follow
along.
Start recording: Select a pattern number, enter a name
for the pattern, and then click OK to save the pattern.
Move the camera using directional, zoom, and focus
buttons and then click Stop recording to save the
pattern profile. You can record up to two minutes of
movement.
– Directional Buttons (
Used to tilt and pan the camera.
– Zoom (
): Zoom in and out.
– Focus ( ): Adjust camera focus to far or near.
– Speed: Specify the camera's panning and tilting
speed.
● Test: Select a pattern profile and then click Test to test
it.
● Edit: Used to edit the selected pattern profile.
● Remove: Used to remove the selected pattern profile.
4 Tour
Used to set up a tour profile of multiple functions in a
designated sequence.
● Set: Used to set up a tour profile.
– Name: Enter a name for the tour profile.
– Function: Indicates the order of the function in the
tour sequence.
):
– Dwell Time (sec.): Specify how long to perform the
selected function for.
– Speed: Specify the preset speed.
● Test: Select a tour profile and then click Test to test it.
● Edit: Used to edit the selected tour profile.
● Remove: Used to remove the selected tour profile.
Select Apply after setting up a preset, scan,
pattern, or tour profile to see images from the
concerned camera on the left side of the screen.
Selecting Apply or OK displays a popup screen
that indicates whether the profile has been set up
successfully.
Part 2 - Configuration
51