Main Monitor; Status Setup; Camera - Idis DirectIP DR-1304P Operation Manual

Part 2 - Configuration

Main Monitor

Configure monitor-related settings.
● Mode: Select Full Sequence or Cameo Sequence.
● Interval: Select between 3 secs and 2 mins. For more
information on Sequence, refer to the 7 Sequence on
page 24.
● Manual Configuration: Set the resolution manually
regardless of the resolution supported by the monitor.
● Resolution: Select from 1920 x 1200, 1920 x 1080,
1680 x 1050 and 1600 x 1200.
● Event Monitoring On: With Event Monitoring
enabled, the camera screen linking event monitoring
is shown. For more information on Event Monitoring,
refer to the Event Monitoring on page 28.
● Event Alert: With Event Alert selected, the red line
appears on the top of the camera screen linking event
monitoring when an event occurs.
• Supported resolutions may be restricted
depending on the monitor.
• We recommend using 1920 x 1080 resolution.
• If you use a VGA monitor as the main display, we
recommend that you use a resolution of 1920 x
1080 or below.
• HDMI deep color feature is not supported.
● Use BRP(Boost Remote Performance) mode : With
BRP mode on, the camera full screen does not display
in live mode and the network bandwidth can limit to
50Mbps.
● Priority : Select the camera's live stream priority,
either resolution or frame rate.
70

Status Setup

Refer to the Menu Use on page 30 for basic
information on using the Setup menus.

Camera

This screen displays an overview of camera events.
When an event occurs, the corresponding channel
flashes for 5 seconds.
Event Types
Motion
Tampering
PIR
Trip Zone
Video Loss
Auto Tracking