Vin - Idis DR-8300 Series Operation Manual

IPv6_Manual
• Manual lets you configure related settings
manually. Configure IP Address, Prefix Length,
Gateway, and DNS Server settings manually using
the remote control's arrow buttons or the virtual
keyboard.
• When registering NVR with the IDIS mobile
application, you can easily enter the IP address
using the QR code.
IPv6_Link-local
Configure the Link-local address. It is used by nodes
when communicating with neighboring nodes on the
same link.

VIN

Designate the interface type as Network Bridge or
Bonding 4.
● Network Bridge: It works with Network Bridge
conforming to IEEE 802.1d standard. The VIN port
can be used like a network switch on network bridge
mode.
● Bonding 4: It works with the LACP Bonding 4
conforming to IEEE 802.3ad standard. All VIN
ports are combined into one logical port and the
bandwidth based on load balancing can be increased.
The VIN port must be connected to a network switch
supporting LACP (Link Aggregation Control Protocol).
● IP Settings: If the camera is networked but not
scanned, use this setting. This setup allows you to
change the network setting of the NVR's VIDEO IN
port which is camera's network environment. Check
the camera's network setting first before you use this
setup.
For more information on the IP setting, refer to Third
Party Scan on page 15.
Part 2 - Configuration
93