Video-Analytics_Loitering - Idis DR-8300 Series Operation Manual

Part 2 - Configuration
● Actions: Specify which actions to take when Alarm-In
is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
74

Video-Analytics_Loitering

● No.: Select which cameras to apply Loitering to.
● Minimum Inside Time: An event occurs when object
loiters within the area for a set period of time after the
object has been detected.
● Area: Set the area to monitor the movement of
objects.
● Ignore Condition: Set the condition to ignore them
when the events occur.
– Ignore Condition: The system does not produce
event log entries or issue remote notifications
regarding event for the spcified time after the initial
event was detected. Set the value between 1 sec
and 5 secs or choose Never. Ignore Condition does
not affect Loitering recording.
– Use Ignoring Time: Loitering detection will be
disabled during the specified time.
● Actions: Specify which actions to take when
Tampering is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.