Main Monitor; Status Setup; Event - Idis DR-6100P Series Operation Manual

Main Monitor

Configure monitor-related settings.
● Mode: Select Full Sequence or Cameo Sequence.
● Interval: Select between 3 secs and 2 mins. For more
information on Sequence, refer to the 8 Sequence on
page 23.
● Use BRP(Boost Remote Performance) mode : With
BRP mode on, the camera full screen does not display
in live mode and the network bandwidth can limit to
100Mbps.
● Use Corridor Format: Divides the screen into 3 panes.
This format displays vertically and is set to display
the optimized video of the camera when using the
camera's pivot feature. This is particularly effective
when monitoring hallwways, passages, and other
confined spaces. (
The 32-channel model does not support
this feature.)
● Manual Configuration: Set the resolution manually
regardless of the resolution supported by the monitor.
● Resolution: Select 1920 x 1200, 1920 x 1080, 1680 x
1050, 1600 x 1200.
● Event Monitoring On: With Event Monitoring
enabled, the camera screen linking event monitoring
is shown. For more information on Event Monitoring,
refer to the Event Monitoring on page 26.
● Event Alert: With Event Alert selected, the red line
appears on the top of the camera screen linking event
monitoring when an event occurs.
• Supported resolutions may be restricted
depending on the monitor.
• We recommend that you use 1920 x 1080
resolution.

Status Setup

Refer to the Menu Use on page 29 for basic
information on using the Setup menus.

Event

This screen displays an overview of all events.
When an event occurs, the corresponding channel
flashes for 5 seconds.
Event Types
Motion
Tampering
Video Loss
Recording Fail
Check Alarm-In
Face Detection
Part 2 - Configuration
Trip Zone
Alarm-In
Audio Detection
Text-In
Fan Error
75