Callback - Idis DR-8300 Series Operation Manual

Part 2 - Configuration

Callback

Configure Callback settings.
Enter the IP address of the receiving server and set
Retry to between 1 and 10 in case of connection failure.
Select the Setup... button at the lower right corner of the
screen to configure Callback Retry Policy.
● Short-Term Retry Policy: Configure short-term policy
to retry a callback event.
– Retry: Number of times to retry a callback event.
– Dwell: Wait time (in seconds) between retry
attempts
● Long-Term Retry Policy
– Use: Configure long-term policy to retry a callback
event.
– Retry: Number of times to retry a callback event.
– Dwell: Wait time (in minutes) between retry
attempts
– Check Interval: Interval time (in minutes) to check
failover.
In a general wired network communication
environment, not a wireless (mobile) /
satellite communication environment where
communications failures are frequent, long-term
retry policies (LTRPs) are not required, except for
particular cases.
● Max. Queue Size : Determine the maximum number
98
that can be processing events. You can limit from 300
to 1000 queues. For more information on Callback
Retry Policy, refer to the graph below.