Additional Event_Anpr - Idis DR-8300 Series Operation Manual

Part 2 - Configuration
● Line Delimiter: Designate a string to mark the end of
a line. You can enter control strings by selecting
and then entering ^, followed by a letter. For example,
Carriage Return is ^M and Line Feed (new line) is ^J.
● Ignore String: Specify a string to ignore from
transaction records.
● Case Sensitive: Ignores case in strings designated
under Transaction Start, Transaction End, Line
Delimiter, and Ignore String.
Case Sensitive does not apply to control strings.
● Time Out: Once Time Out has been enabled, the
system will assume the end of a transaction if no new
string is entered within the specified duration of time.
Select between 5 secs and 15 mins.
Selecting RS-232, RS-485, USB-Serial 1 through 8, or LAN
1 through 16 as the port activates the Port Setup button.
Select Setup and configure the Baud Rate, Data Bit,
Stop Bit, and Parity settings.
• If any one of LAN1 through 16 has been selected as
the port, select the Port Setup button and configure
the network port setting.
• If using a USB-serial port, the Text-In feature may
malfunction if the USB cable is removed while the
system is in operation.
● Title: Designate a name for the text-in device.
● Actions: Specify which actions to take when text-in is
detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specific preset position
when an event occurs.
– Event Monitoring: Selects the cameras to monitor when
an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
78

Additional Event_ANPR

● Setup: Configure ANPR devices.
● Port: If any one of the LANs has been selected as the
port, select the Port Setup button and configure the
network port setting.
● ANPR Product: Configure the product to apply ANPR
function.
● Actions: Specify which actions to take when ANPR
event occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by
Mail, LAN1 through 5, Push, HTTP, FTP, and/or Alert
Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.