Event Setup; System Event - Idis DR-8300 Series Operation Manual

Part 2 - Configuration

Event Setup

Refer to the Menu Use on page 34 for basic
information on using the Setup menus.

System Event

Use this option to configure Monitoring settings.
● Settings: Configure when and what the system
should monitor for.
● Actions: Configure alarm-out (NVR alarm-out
channel, NVR beep, camera alarm-out channel) and
notification (email, LAN1 through 5, push, HTTP, alert
window) settings.
64
Monitoring Options
Define monitoring times. If self-
diagnosis is not performed on
System
a regular basis, the system will
assume an error.
Bootup,
Define bootup, restart and
Restart, shutdown actions.
Shutdown
Panic Record
Define panic recording actions.
The system will assume an error
if the system has been scheduled
to record normally but recording
does not take place during
scheduled intervals.
Check
Recording
The system will assume an error
if the alarm-in status does not
Check Alarm-
change during the specified
In
monitoring interval while alarm-in
is active.
Generates an event if the disk
Disk Almost
reaches the specified capacity
Full
(80% to 99%).
Generates an event when the disk
of one of two groups reaches the
specified capacity (80% to 99%).
Disk Partially
For more information on the disk
Almost Full
group, refer to HDD Installation
Precautions on page 43.
Select Schedule On and then
configure the days of the week,
times, and monitoring interval.
Select the button on the
bottom left of the screen to add
a schedule. Select icon to
delete the schedule.