Part 5 - Appendix; Nat Function Example - Idis DR-8300 Series Operation Manual

Part 5 - Appendix

NAT Function Example

NAT function is to connect to the camera which is internal VIN network from the physically divided WAN network PC
(WebSetup / IDIS Web / IDIS Center program / RTSP).
To connect to the camera WebSetup / IDIS Web / IDIS Center program / RTSP function, you need to configure the NAT
rule to forward ports from NVR port number to the camera port number.
NAT Configuration Guide
1 3 5
2 4 6
WAN (Ethernet 0)
IP Address: 10.0.125.211
Getway: 10.0.0.1
PC (WEB Setup / IDIS Web / IDIS
Center program / RTSP)
• To use NAT function, the camera gateway address must be set to the VIN network IP address of the NVR.
• For more information on the IP address of the camera and port number, refer to the WebSetup page of the camera
manual. Also, check the IP address of the camera in the NVR or default port number on the camera manual.
7 9 11 13 15
8 10 12 14 16
NVR
VIDEO IN (Ethernet 1)
IP Address: 169.254.123.72
.
.
.
32EA
129