Main Monitor; Status Setup; Camera - Idis DR-2516P Operation Manual

Main Monitor

Configure monitor-related settings.
● Mode: Select Full Sequence or Cameo Sequence.
● Interval: Select between 3 secs and 2 mins. For more
information on Sequence, refer to the 8 Sequence on
page 24.
● Manual Configuration: Set the resolution manually
regardless of the resolution supported by the monitor.
● Resolution: Select from 3840 x 2160, 1920 x 1200,
1920 x 1080, 1680 x 1050 and 1600 x 1200.
● Use VGA Output Always: Screen can output even if
the VGA monitor is not connected.
● Event Monitoring On: With Event Monitoring
enabled, the camera screen linking event monitoring
is shown. For more information on Event Monitoring,
refer to the Event Monitoring on page 28.
● Event Alert: With Event Alert selected, the red line
appears on the top of the camera screen linking event
monitoring when an event occurs.
• Supported resolutions may be restricted
depending on the monitor.
• 3840 x 2160 @ 50/60Hz resolution is supported
only in HDMI 2.0 monitor.
• We recommend using 3840 x 2160 or 1920 x 1080
resolution.
• If you use a VGA monitor as the main display, we
recommend that you use a resolution of 1920 x
1080 or below.
• HDMI deep color feature is not supported.
● Use BRP(Boost Remote Performance) mode : With
BRP mode on, the camera full screen does not display
in live mode and the network bandwidth can limit to
100Mbps.
● Priority : Select the camera's live stream priority,
either resolution or frame rate.

Status Setup

Refer to the Menu Use on page 33 for basic
information on using the Setup menus.

Camera

This screen displays an overview of camera events.
When an event occurs, the corresponding channel
flashes for 5 seconds.
Event Types
Motion
Tampering
Audio Detection
PIR
Loitering
Obejct Detection
Face Detection
Disk Bad
Part 2 - Configuration
Trip Zone
Video Loss
Camera Fan Error
Auto Tracking
Line Crossing
Intrusion
Storage
Disconnected
113