Camera System - Idis DR-8300 Series Operation Manual

Generates an event when the
disk of one of two groups reaches
Disk Partially
their maximum capacity. For more
Full
information on the disk group,
refer to HDD Installation
Precautions on page 43.
Generates an event when all disks
Disk Full
reach their maximum capacity.
Generates an event when the
specified percentage of the
Disk Bad
disk becomes damaged. Set to
between 10% and 90% in 10%
intervals.
Specify the threshold temperature.
Disk
Once any disk reaches this
Temperature
threshold, the system will issue an
alert.
Monitors disks that support
Disk
S.M.A.R.T. and notifies the user if a
S.M.A.R.T.
disk error is detected.
Notifies the user when the fan
Fan Error inside the system (CPU fan, HDD
fan 1, HDD fan 2) malfunctions.
Notifies the user if an eSATA device
eSATA
Disconnected becomes disconnected while in use.
It will be highlighted when the NVR
Disk Config
reboots after the hard disk drive has
Change
been replaced.
No Storage It will be highlighted when no hard
Found
disk drive has been connected.
It will be highlighted when login
Consecutive
fails by entering a wrong password
Invalid PW
for consecutive attempts.
It will be highlighted when the
Redundant redundant power is disconnected.
Power Error (This feature is supported only with
DR-8364D/DR-8364FD model)
It will be highlighted when the RAID
RAID BROKEN
configuration is broken.
It will be highlighted when one of
Degrade
the HDDs composing RAID is in
error.
• For system events, only an e-mail notification of
actions can be selected.
• In order to use the Notify(Callback) feature, the
NVR must be registered to the remote program on
the receiving PC's end.
• For more information on the RAID Broken and
refer to RAID Configuration Error
Degrade,
on page 44.

Camera System

A list of events that occur in the camera except for video
analysis.
Part 2 - Configuration
65