Ds3/Ec1 And Tmux Cable Routing - Alcatel-Lucent 1665 Installation Manual

Equipment and cable installation
............................................................................................................................................................................................................................................................
Figure 1-15 DS3/EC1 and TMUX cable routing
Note:
........................................................................................................................................................................................................................
5
Route the cables along the cable rack and into the terminating bay (DSX or other
terminating transmission equipment).
........................................................................................................................................................................................................................
6
Cut the cables to desired length and install the BNC connectors shipped with the cable
assemblies.
Note:
carefully to ensure a proper connection. Failure to do so may result in faulty DS3
signals as a result of improperly installed BNC connectors.
........................................................................................................................................................................................................................
7
Connect the cables to their respective positions on the terminating equipment.
Note:
the circuit pack not the backplane. There is no issue interchanging these cables on the
backplane. The Signals are common between both cables.
........................................................................................................................................................................................................................
8
Verify DS3 cabling using the LNW74 TESTPK or equivalent method.
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
This figure shows DS3 cabling for FNA and FNB.
When installing BNC connectors, follow the manufacturer's instruction
The 12-port cable and the 24-port cable use different signal grounds based on
DS3/EC1 and TMUX 48-port cable installation
1 - 4 3