Table of Contents
Advertisement
2.4
GENERAL REGULATIONS FOR USE
When transporting a load, keep the accessory at a maximum height of 300 mm from the
ground.
Where possible avoid winding roads, otherwise, move cautiously and very slowly.
Respect the limits imposed by the load diagram referred to the accessory being used. If a different accessory
from that delivered with the machine is purchased at a later time, please contact the Manufacturer to obtain
the correct load diagram.
If the material to be moved is on a supporting base, before lifting it with the material, ensure that it is in
good condition and can withstand the weight to be lifted.
Never lift a strapped load with the forks; use the specific accessory. The edges of the forks could in fact cut
the lifting cables due to the weight, thereby causing the loss of material. In any case, never lift a load with
only one arm of the fork.
When transporting a suspended load from a rope, do not allow it to swing excessively, otherwise, stop
immediately and wait for the load to stabilise before proceeding.
When transporting a load with a mobile centre of gravity, such as a liquid, avoid sudden acceleration and
braking. Be very careful when the route has a slight gradient.
Immediately after use, place the accessory in a horizontal position and if it seems unstable, prop it with
suitable and safe supports to make it stable.
It is forbidden to operate the machine under the influence of alcohol and/or drugs and/or medicine, which
alters the physical and mental condition.
2.5
WORKING ON SITE
Operate in good physical and mental conditions.
It is forbidden to operate the machine under the influence of alcohol and/or drugs.
It is mandatory to wear a safety belt.
You must wear ear plugs or hearing protection headphones in case of excessive noise. A safety helmet must
be worn in case of the risk of objects falling from above, even if the machine's driver cabin is designed to
protect against such a risk.
Keep the machine as far as possible from the edges of excavations or the road and always examine the
conformation and the condition of the work area in relation to the dimensions of the machine in the
various configurations.
Identify the best route toward the work area.
Ground capacity characteristics:
o Turned soils, soft ground, land filled ground
o Average particle size sand
o Gravel
o Clay soil
o Rocky ground
Snorkel International, LLC
2009 Roseport Road
Elwood, KS 66024
www.snorkellifts.com
26
Model: Snorkel SR9244 SR1054
Part Number: 159-0037-000
2
0-1 kg/cm
2
2-2.5 kg/cm
2
3-4 kg/cm
2
2-4 kg/cm
2
10-15 kg/cm
Advertisement
Table of Contents
