Description Of The Controls; Control Levers On The Steering Column; Left Lever Of The Steering Wheel (Stalk); 3.1.1.2 Lever On The Right Of The Steering Wheel - Snorkel SR9244 Operator And Maintenance Manual

Table of Contents

Advertisement

3.1

DESCRIPTION OF THE CONTROLS

3.1.1

CONTROL LEVERS ON THE STEERING COLUMN

3.1.1.1 LEFT LEVER OF THE STEERING WHEEL (STALK)

Lever operation is only enabled if you have selected from the display to use
the FNR function from the lever and not from the joystick.
To enable the forward drive of the machine (F), pull the lever towards the
steering wheel and move it forward. The letter "F" will appear on the
display on the front right dashboard.
To enable the reverse drive of the machine (R), pull the lever towards the
steering wheel and move it back. The letter "R" will appear on the display
on the front right dashboard.
Enable the neutral gear (N) by moving the lever to the central position.
The lever controls do not operate when:
-
the parking brake is engaged
-
the operator is not sitting in the driver's seat.
-
The outriggers are complete extended (if not completely lifted, a
message appears on the display).
For the function of the button located at the top of the lever, see the "Levelling the Machine" paragraph*.
In the guide below the left lever of the steering wheel is referred to as the "stalk."
The lever can be used solely if the steering mode is with the front wheels only It is
dangerous to change the driving direction when the machine is moving at high
speed; the machine suddenly inverts the driving direction; before changing direction,
allow the machine to reduce speed to a minimum. When reverse drive is selected an
acoustic signal will sound to indicate the risk of danger to any people in the
manoeuvring area.
Attention! If the operator leaves the driver's seat, the neutral gear "N" is automatically engaged after 3
seconds. Operation of the lever is disabled if the "concentric" and/or "crab" steering mode is selected.

3.1.1.2 LEVER ON THE RIGHT OF THE STEERING WHEEL

Lights control
Rotate the lever by holding it from the knurled part until the desired
symbol of the rotating part is aligned with the horizontal line of the fixed
part. 3 positions are possible:
-
Position 0 = lights off
-
Position 1 = parking lights on
-
Position 2 = low beam lights on
Snorkel International, LLC
2009 Roseport Road
Elwood, KS 66024
www.snorkellifts.com
50
Model: Snorkel SR9244 SR1054
Part Number: 159-0037-000

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sr1054

Table of Contents