Table of Contents
Advertisement
5.12.5
CHECK THE AUXILIARY PARTS BELT CONDITIONS AND
TENSION
Proceed only with the engine stopped and at a low temperature so as to prevent burns. Make sure the belt
is not torn, worn or soiled with lubricants or fuels. Otherwise, contact the assistance service for
replacement.
5.12.6
CHECKING THE INTEGRITY OF THE EXHAUST PIPE/S
Visually check that the gas exhaust system is not blocked or damaged. Make sure there are no potential
dangerous fumes inside the machine. If necessary, contact the assistance service
5.12.7
CHANGE THE ENGINE OIL
This operation must be carried out by qualified personnel.
Only proceed with the engine stopped and at a low temperature in order to avoid the risk of burns. Remove
the closing sheet used for protection in the lower area of the engine compartment.
•
Place a container under the drain plug (1) to collect the spent oil.
•
Unscrew the plug and wait for the sump to be emptied completely and then tighten the plug again
with a new gasket.
•
Top-up through the inlet on the distribution lid (2) with the same type of oil and according to the
quantity indicated below.
•
Use the dipstick to verify that the level of oil is between the "Min" and "Max" (3) limits
•
Dispose of the spent oil according to the relevant regulations in force.
Use the oil with the specifications below.
1
Snorkel International, LLC
2009 Roseport Road
Elwood, KS 66024
www.snorkellifts.com
2
126
Model: Snorkel SR9244 SR1054
Part Number: 159-0037-000
3
Advertisement
Table of Contents
