Table of Contents
Advertisement
5.1
GENERAL INFORMATION
•
Park the machine on level ground.
•
The work area must be clean and dry.
•
Maintenance, repair and adjustment operations must be carried out by qualified and skilled
personnel with the machine switched off.
•
It is forbidden to carry out maintenance when the machine is moving.
•
The frequency indicated in this manual must be complied with. Damaged or worn parts must be
immediately repaired or replaced.
•
Always keep the machine clean from debris and eliminate any grease or oil deposits.
•
Isolate the battery if arc welding is to be carried out on the machine or work is to be performed on
the wiring system.
•
If electric arc welding must be performed, disconnect the transmission control units inside the
general electrical box.
•
If electric arc welding must be performed, disconnect the diesel engine control units.
•
When arc welding, connect the welder mass to a point in direct contact with the area to be
welded avoiding intervention on sliding parts such as joints, bearings, hydraulic cylinders.
•
Wear protective glasses and mask when using compressed air for cleaning. Do not direct the jet
towards the skin or the eyes.
•
Use gloves and glasses when handling detergent liquids and/or lubricants.
•
After maintenance and before enabling the machine, make sure that any safety devices removed
previously have been restored.
•
If the machine must be lifted, make sure it is supported on a solid and safe base.
•
When operating under mobile lifted parts (e.g. telescopic boom), block the hydraulic cylinder
movements with the spacers and rest them on top of safe and strong supports.
Snorkel International, LLC
2009 Roseport Road
Elwood, KS 66024
www.snorkellifts.com
116
Model: Snorkel SR9244 SR1054
Part Number: 159-0037-000
Advertisement
Table of Contents
