Heat Exchanger - Snorkel SR9244 Operator And Maintenance Manual

5.13

HEAT EXCHANGER

Every day the operator must verify that the air inlet surfaces of the radiators have no impurities (dust, mud,
straw, etc.). If necessary, clean them with compressed air or pressurised water. If the machine has the
"REVERSING FAN" accessory function, it must be regularly used to clean the radiator.
Attention: The engine must be switched off during operation. Hazardous for the operator. Moving parts.
If necessary, remove the front grids of the engine compartment and wash them thoroughly. Remove each
grid by turning the locking lever clockwise until it clicks. Once it is cleaned, insert it properly in the rails (be
careful as the two grids are not the same) and press the grid towards the closure until it stops. Repeat the
operation for the second grid.
If necessary, allow the water and impurities to drain by removing the grid below. Once cleaned, reassemble
the grid.
Snorkel International, LLC
2009 Roseport Road
Elwood, KS 66024
www.snorkellifts.com
130
Model: Snorkel SR9244 SR1054
Part Number: 159-0037-000