D Keyer Set Menu (Cw-Key Set) - Icom IC-7300 HF Plus Full Manual

Previous view
4
RECEIVING AND TRANSMITTING
Operating CW (Continued)

D Keyer set menu (CW-KEY SET)

In this menu, you can set the memory keyer repeat
time, dash weight, paddle specifications, key type,
and so on.
Setting example
1. Open the CW-KEY SET menu in the CW mode.
» KEYER > EDIT/SET > CW-KEY SET
MENU
2. Select the setting item.
(Example: Side Tone Level)
CW-KEY SET menu
3. Adjust the Side Tone Level.
(Example: 80%)
4. To close the KEYER screen, push
times.
Side Tone Level
Adjust the CW side tone output level.
• Adjust to between 0 and 100%.
Side Tone Level Limit
Turn the CW side tone level limit ON or OFF. This
disables the CW side tone when you rotate
(inner) above the side tone level.
Keyer Repeat time
Set the time between Memory keyer transmissions.
• Set to between 1 and 60 seconds.
Dot/Dash Ratio
Set the dot/dash ratio.
• Set to between 1:1:2.8 to 1:1:4.5 in 0.1 steps.
Keying weight example: Morse code "K"
Rotate
Push
Rise Time
Set the rise time of the transmitted CW envelope.
• Set to 2, 4, 6 or 8 milliseconds.
Key action
TX output
power
Paddle Polarity
Set the paddle dot-dash polarity to Normal or
several
EXIT
Reverse.
• Normal: Right = dash, Left = dot
• Reverse: Right = dot, Left = dash
(Default: 50%) Key Type
Set the key type for the [KEY] connector on the rear
panel.
• Set to Straight, Bug or Paddle.
(Default: ON)
MIC Up/Down Keyer
Set the microphone [UP]/[DN] keys to use as a CW
AF RF/SQL
key.
• ON:
(Default: 2sec) • OFF:
LThe [UP]/[DN] keys do not work as a "squeeze key."
L When "ON" is selected, you cannot change the frequency
and the Memory channels using the [UP]/[DN] keys.
TIP: How to reset to the default setting
Touching the item or its option for 1 second displays the
Quick menu, and then touch "Default" to reset to the
default setting.
4-21
Dot Dash
1 1
Default: 1:1:3
1 1 2.8〜4.5
Setting range
1:1:2.8 to 1:1:4.5
Setting range
TX
RX
0
Rise time
Use the [UP]/[DN] keys as a CW key.
Do not use the [UP]/[DN] keys as a CW key.
(Default: 1:1:3.0)
Dash
3
Space
(Default: 4ms)
Set TX output power
Time
(Default: Normal)
(Default: ELEC-KEY)
(Default: OFF)