Icom IC-7300 HF Plus Full Manual page 121

Previous view
12
SET MODE
Function (Continued)
SPEECH Level
Sets the Voice Synthesizer audio output level.
• Range: 0 ~ 100%
[SPEECH/LOCK] Switch
Selects action.
SPEECH
• SPEECH/LOCK: Pushing
Synthesizer function.
Holding down
function ON or OFF.
• LOCK/SPEECH: Pushing
function ON or OFF.
Holding down
Voice Synthesizer function.
Lock Function
This function electronically locks
the panel display* to prevent setting changes by
accidental operation.
* Keys and dials are also locked except for
, POWER , and
AF RF/SQL
• MAIN DIAL:
MAIN DIAL
MAIN DIAL
L
an item in the Set mode or Quick menu.
• PANEL: The panel operation is disabled.
Memo Pmd Qumntity
Sets the number of memo pad channels.
• 5: 5 channels.
• 10: 10 channels.
MAIN DIAL Auto TS
Sets the Auto Tuning Step function for
When rapidly rotating
MAIN DIAL
automatically changed according to the rotation speed.
• OFF: Auto tuning step is turned OFF.
• LOW: Approximately 2 times faster.
• HIGH: Approximately 5 times faster when the tuning
step is set to 1 kHz or smaller steps.
Approximately 2 times faster when the tuning
step is set to 5 kHz or larger steps.
MIC Up/Down Speed
Sets the response speed of [∫]/[√] on the supplied
microphone while holding down.
• Slow: Slow speed (25 tuning steps/second).
• Fast: Fast speed (50 tuning steps/second).
(Default: 50%)
(Default: SPEECH/LOCK)
turns ON the Voice
SPEECH
turns the Lock
SPEECH
turns the Lock
SPEECH
turns ON the
SPEECH
(Default: MAIN DIAL)
or
MAIN DIAL
,
AF RF/SQL
.
SPEECH
is disabled.
functions only when selecting
(Default: 5)
(Default: High)
.
MAIN DIAL
, the tuning step is
(Default: Fast)
Quick RIT/∂TX Clemr
Selects the operation of
functions.
• OFF: Clears when
second.
• ON: Clears when
[NOTCH] Switch (SSB)
[NOTCH] Switch (AM)
Selects the notch function used in the SSB or AM
mode.
• Auto: Only the Auto notch filter.
• Manual: Only the Manual notch filter
• Auto/Manual: Both the Auto and Manual notch filters.
SSB/CW Synchronous Tuning
Turns the Displayed Frequency Shift function ON or
OFF.
This function automatically shifts the frequency to
match the CW pitch when the operating mode is
toggled between SSB and CW.
• OFF: Stays on the frequency even when the
operating mode is toggled between SSB and
CW.
• ON: Shifts the frequency when the operating mode
is toggled between SSB and CW, to keep
receiving the signal.
CW Normml Side
Selects the carrier point in the CW normal mode.
• LSB: The LSB side.
• USB: The USB side.
12-6
(Default: OFF)
for the RIT and ∂TX
CLEAR
is held down for 1
CLEAR
is pushed.
CLEAR
(Default: Auto/Manual)
(Default: Auto/Manual)
(Default: OFF)
(Default: LSB)