Icom IC-7300 HF Plus Full Manual page 10

Previous view
1
PANEL DESCRIPTION
Front panel (Continued)
#4
@0 MEMO PAD KEY
MPAD
Sequentially calls up the contents in the Memo
Pads, or saves the displayed contents into the
Memo Pad.
@1 VFO/MEMORY KEY
Switches between the VFO and Memory mode, or
copies the memory channel contents to the VFO.
@2 CLEAR KEY
CLEAR
Clears the RIT (p. 4-3) or TX shift frequency
(p. 4-11).
@3 A/B KEY (p. 3-2)
A/B
Switches between VFO A and VFO B, or sets the
selected VFO's frequency to the other VFO.
TX KEY TX (p. 4-11)
@4
Turns the TX function ON or OFF.
@5 RIT KEY (p. 4-3)
RIT
Turns the Receiver Incremental Tuning (RIT)
function ON or OFF.
@6 SPLIT KEY (p. 4-13)
SPLIT
Turns the Split function ON or OFF.
@7 MULTI-FUNCTION CONTROL
Displays the Multi-function menu for various
adjustments, or selects a desired item.
#3 #2 #1 #0
(p. 9-6)
(p. 3-2)
V/M
MULTI (p. 1-7)
@9 @8 @7 @6
@8 TRANSMIT FREQUENCY CHECK KEY
(p. 4-13)
Enables you to monitor the transmit frequency while
holding it down in the Split mode.
@9 TX/RX INDICATOR (p. 3-10)
Lights red while transmitting and lights green while
receiving.
#0 NOISE REDUCTION KEY
Turns the Noise Reduction function ON or OFF.
#1 NOTCH KEY
NOTCH
T urns the Notch filter ON or OFF.
#2 TWIN PASSBAND TUNING CONTROL
(p. 4-5)
A djusts the IF filter's passband width by rotating,
and clears the setting by holding down for 1 second.
#3 PREAMP/ATTENUATOR KEY
Turns ON or OFF, and selects one of two receive
RF preamplifiers or turns the Attenuator ON or OFF.
#4 NOISE BLANKER KEY
Turns the Noise Blanker ON or OFF.
1-3
@5 @4 @3
@2
@1
@0
XFC
(p. 4-9)
NR
(p. 4-9)
TWIN PBT
(p. 4-3)
P.AMP
ATT
(p. 4-8)
NB
CLR