Icom IC-7300 HF Plus Full Manual page 166

Previous view
19
CONTROL COMMAND
Remote control (CI-V) information (Continued)
• Scope waveform data
Command : 27 00
Outputs the waveform data to the controller
q w e r
0 0 X X X X X X
Fixed
w Division number (Current):
e Division number (Maximum):
When sent through the USB port, the data is
divided by 11 and sent in sequential order.
The 1st data sends only the wave information (q ~
y) without the waveform data (u).
The 2nd or later data sends the minimum wave
information (q ~ e) with waveform data (u).
r Center or Fixed mode data
• 00 = Center mode scope, 01 = Fixed mode scope
t Waveform information
The waveform information is different between
Center mode and fixed mode.
• In the Center mode: Center frequency and span
See page 19-9 for Frequency data, and the Scope
span settings to the right.
• In the Fixed mode: Lower edge and higher edge
frequencies are sent.
See page 19-14 for Scope Fixed edge frequency
settings e ~ !2 .
y Out of range information
• 00 = In range, 01 = Out of range
If the scope data is out of range, the waveform
data (u) is omitted.
u Waveform data
The transceiver outputs the drawn waveform data.
The data range or data length of the waveform
data is judged by the controller. (The data range is
basically the same as the display size of the scope
on the controller.)
Data range 0~160
Data length 475
t y u
X X X X X X ...... X X
01~11
11 (USB)
are sent.
• Center/Fixed mode settings
Command: 27 14
0 0 X X
Fixed
• Scope span settings
Command : 27 15
q w e
0 0 0 0 X X X X 0 0 0 0
• Scope Edge number settings
Command: 27 16
0 0 X X
Fixed
• Scope Hold settings
Command: 27 17
0 0 X X
Fixed
• Scope Reference level settings
Command : 27 19
0 0 X X X 0 X X
L Adjustable range: –20.0 dB ~ +20.0 dB in 0.5 dB steps
19-12
00=Center mode
01=Fixed mode
r t y
Span (Hz)
2500 2.5 k
5000
10000
25000
50000
100000 100 k
250000 250 k
500000 500 k
01=Edge 1
02=Edge 2
03=Edge 3
00=Hold OFF
01=Hold ON
00= + (plus)
01= – (minus)
5 k
10 k
25 k
50 k