Icom IC-7300 HF Plus Full Manual page 156

Previous view
19
CONTROL COMMAND
Remote control (CI-V) information
D CI-V connection
The transceiver's operating frequency, mode, VFO
and memory selection, can be remotely controlled
using a PC.
Choose your connection method from the following:
• A USB cable (A-B type, user supplied)
The required USB driver and driver installation guide
can be downloaded from the Icom web site.
Go to "http://www.icom.co.jp/world," and then click
"Support," "Firmware Updates / Software downloads"
in sequence.
L The download procedure on the web page may be
changed without notice.
• The optional CT-17
CI-V level converter
Connects to a PC with an RS-232C port.
D Preparing
The Icom Communications Interface V (CI-V) is used
for remote control.
To control the transceiver, first set its address, data
communication speed, and transceive function. These
settings are set in Set mode.
D Data format
The CI-V system can be written using the following
data formats. Data formats differ according to
command numbers. A data area or sub command is
added for some commands.
Controller to IC-7300
q w
FE FE 94
FE FE E0
q w
IC-7300 to controller
.
e r t y
E0 Cn Sc Data area
94 Cn Sc Data area
e r t y
• Connection example (using CT-17)
IC-7300
OK message to controller
u
FD FE FE E0
FD FE FE E0
u
NG message to controller
19-2
9~15 V DC
PC
ct-17
mini-plug cable
94 FB FD
94 FA FD