Sensor Setup - Lutron Electronics GRAFIK Eye QS Quick Installation And Operation Manual

Occupancy Sensor Setup
Associating wireless occupancy sensors and GRAFIK Eye QS Wireless control units
(for wireless enabled units only):
1. Make sure the wireless mode of the GRAFIK Eye QS control unit
Main menu
is "Enabled".
Zone Setup
2. Enter programming mode.

Sensor Setup

3. Use the Master buttons to highlight "Sensor setup" and press
the OK button to accept.
4. Use the Master buttons to highlight "Add wireless sensors" and
Sensor Setup
press the OK button to accept.
5. Press and hold the "Lights Off" button (g on some sensors) on
Add wireless sensors
the occupancy sensor for 6 seconds. The lens will start flashing
and the info screen on the GRAFIK Eye QS Wireless control unit
Daylight
will display the sensor's serial number.
6. Press the OK button on the GRAFIK Eye QS control unit. A
Add wireless sensors
screen will confirm that the sensor has been assigned.
(To disassociate a wireless occupancy sensor from the GRAFIK
Initiate association
Eye QS control unit, Refer to the Radio Powr Savr occupancy
of sensors
sensor install guide to return the sensor to its "out-of-box"
functionality. Doing so will remove its programming from the
GRAFIK Eye QS control unit.)
Occupancy
7. Repeat the above steps for all desired sensors.
8. Exit programming mode.
xxxx-xxxx
Associating wireless occupancy sensors through
Press OK to Save
QS Sensor Modules (QSM):
1. Press and hold the Program button on the QSM for 3 seconds
to enter programming mode. There will be 1 audible beep
and the Status LED will begin flashing. The info screen on the
Saved
*Assigned*
GRAFIK Eye QS control unit will display that the QSM is in
programming mode.
2. Press and hold the "Lights Off" button (g on some sensors) on
the occupancy sensor for 6 seconds. There will be 3 audible
beeps from the QSM to verify association.
3. Press and hold the Program button on the QSM for 3 seconds
to exit programming mode.
Note: The wireless signal has a range of 30 ft (9 m) through
®
1 9
standard construction or 60 ft (18 m) line of sight.
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with EcoSystem Control Unit Quick Installation and Operation Guide 18
2 10 3 11 4 12 5 13 6 14 7 15 8 16
9-16
1-8
OK
Radio Powr Savr
Occupancy Sensors
QS Sensor Module (QSM)
Master
buttons
OK
button
Timeclock
(back) button
Press and hold
"Lights Off" or g
button to associate/
disassociate
Program button