Connecting The Power Supply; Switching On The Photometer And Setting The Language - wtw photoLab 6100 VIS Operating Manual

®
photoLab 6100 VIS
Connecting the
plug-in power pack
ba75849e06 06/2013

3.2.2 Connecting the power supply

The power is supplied via the enclosed plug-in power pack. The power pack
supplies the photometer with low voltage (12 VDC).
CAUTION
The line voltage of the usage location must fulfill the specifications
stated on the power pack (the specifications are also given in chapter 7
T ). Always use the supplied 12 V original power pack
ECHNICAL DATA
only. The power pack is not suitable for operation with older
photometers (ser.no. prior to 1319xxxx).
1
3.2.3

Switching on the photometer and setting the language

During the initial commissioning the photometer automatically guides you to
the setting of the meter language after switching on (<ON/OFF>).
Language
Deutsch
English ✓
Français
Español
Italiano
Bulgarian/Български
Česko
Chinese/ 中文
Traditional Chinese/ 繁體中文
Greek/Ελληνικά
Indonesian/Indonesia
After the initial commissioning, you can change the language in the
General setup / Language menu at any time.
1 Connect the miniplug of the power
pack to the socket (1) of the
photometer.
2 Connect the power pack to an
easily accessible power socket.
1 Select a language with <><>
04/16/07 9:52
2 Confirm the selected language
with <START·ENTER>.
The language has been set.
The currently selected language is
marked by a tick.
The display switches to the setting
of Date and Time.
Commissioning
.
13