Using The All Ports Configuration Dialog Box - Lucent Technologies Cajun P220 Operation Manual

Configuring the Cajun P550 Switch (Layer 2 & Layer 3)
3. To set Fast Start mode on individual ports, in the Name column, click the port
name for the selected module. The Switch Port Configuration dialog box opens.
Or
To set Fast Start mode on all ports in a module, click All Module Switch Port
Configuration. The Switch Port Configuration on All Ports dialog box opens.
4. From the Fast Start pull-down menu, select Enable to enable Fast Start mode on
the selected module ports.
5. Click APPLY to save your changes, or CANCEL to clear your selection.

Using the All Ports Configuration Dialog Box

The All Ports Configuration dialog box allows you to apply the same parameter settings
to all switch ports in a module using a single command.
To set all switch ports in a module using a single command:
1. In the System Configuration section of the Web Agent window, select Modules
& Ports. The Module Information dialog box opens.
2. In the Ports column, click the number of ports listed for the module you want to
configure (for example, 10 for 100Base-FX). The Physical Port Configuration dialog
box opens.
3. Click All Module Ports Configuration at the bottom of the dialog box. The All
Ports Configuration dialog box opens.
4. Select the port on which you want your changes to occur.
5. Set port parameters for the selected ports, as described in "Viewing Switch Port
Parameters", earlier in this chapter.
6. Click APPLY to save your changes, or CANCEL to restore previous settings.
3-22 Cajun P550/P220 Switch Operation Guide