Creating And Modifying Ipx Rip Filters - Lucent Technologies Cajun P220 Operation Manual

Configuring IPX RIP Protocol (Layer 3)
Parameter
Use Max Packet Size
Periodic Update Interval
(sec)
Aging Interval Multiplier
Triggered Updates
Advertise Default Route
Only
Mode
3. Click APPLY to save your changes, or CANCEL to restore previous settings.

Creating and Modifying IPX RIP Filters

To create IPX RIP filters:
1. In the IPX RIP Configuration section of the Web Agent window, click Filters.
The IPX RIP Filters dialog box opens.
2. Click CREATE to create a new filter. The Add IPX RIP Filter dialog box opens.
5-2
Table 5-1. IPX RIP Interface Parameters (Continued)
Allows you to...
Select to enable or disable whether the RIP packets sent out an
interface are set to the maximum transmission size.
• If enabled, RIP packets can contain the maximum
allowed by the MTU of the RIP interface.
• If disabled, RIP packets are limited to 50 network entries.
Specify (in seconds) the interval at which periodic RIP updates
are sent out an interface.
Specify the length of time that information from received RIP
updates are kept as a multiplier of the Periodic Update Interval.
Select to enable or disable RIP updates to be immediately
transmitted to the network in response to changes in the
network topology.
Select to enable or disable the advertising of the default
network exclusively (subject to a route to the default network
being known to the switch).
Select the mode for the RIP interface.
Options include:
• Talk/Listen - Send and receive advertisements.
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
Cajun P550/P220 Switch Operation Guide