5
Configuring IPX RIP Protocol
(Layer 3)
Overview
This chapter and its procedures are specific to Layer 3 configuration.
Included in this chapter:
Configuring IPX RIP Interfaces
Creating and Modifying IPX RIP Filters
IInterpreting IPX RIP Interface Statistics
Configuring IPX RIP Interfaces
To configure the IPX RIP interfaces:
1. In the IPX RIP Configuration section of the Web Agent window, click
Interfaces. The IPX RIP Interfaces dialog box opens.
2. Use Table 5-1 to configure the IPX RIP interfaces:
Parameter
Select
Interface
Network Number
Use Interpacket Gap
Cajun P550/P220 Switch Operation Guide
Table 5-1. IPX RIP Interface Parameters
Allows you to...
Select a RIP interface to modify.
Note:
This field is displayed in the IPX RIP Interface
dialog box, not the Add IPX RIP Interface dialog
box.
Identify the IPX interface associated with the RIP interface.
Identify the number of the IPX network associated with the
VLAN.
Select to enable or disable whether RIP updates sent out over
an interface have an interpacket transmission delay.
• If enabled, IPX RIP provides update packets.
• If disabled, IPX RIP periodic update packets have no
interpacket gap.
5-1