Modifying Ospf Areas; Modifying Ospf Interfaces - Lucent Technologies Cajun P220 Operation Manual

Configuring the OSPF Routing Protocol (Layer 3)
2. Select the OSPF area to be removed.
3. Click DELETE. The OSPF area is removed.

Modifying OSPF Areas

To modify an OSPF area:
1. In the OSFP Configuration section of the Web Agent window, click Areas. The
OSPF Areas dialog box opens.
2. Select the OSPF area to be modified.
3. Use Table 9-2 to modify your configuration.
4. Click APPLY to save your changes, or CANCEL to restore previous settings.

Modifying OSPF Interfaces

To modify an OSPF interface:
1. In the OSPF Configuration section of the Web Agent window, click Interfaces.
The OSPF Interfaces dialog box opens.
Note: If OSPF is not enabled for your existing IP interfaces (VLANs) you must first
2. Use Table 9-3 to determine how to modify your OSPF interfaces:
Parameter
Select
Interface
IP Address
Area
DR Priority
Transit Delay
9-4
enable OSPF before you can modify OSPF interfaces. Refer to "Configuring
IP Interfaces" in Chapter 7 for more information on how to enable OSPF on
IP interfaces.
Table 9-3. OSPF Interface Parameters
Definition
Select the OSPF interface to be modified.
Displays IP interface (VLAN) that has OSPF enabled.
Note:
This is a read-only field.
Displays IP address associated with the OSPF interface.
Note:
This is a read-only field.
Enter the area ID configured for this interface.
Enter the decimal value for this interface for DR priority
functionality.
Enter the estimated number of seconds it takes to transmit a link
state update packet over this interface.
Cajun P550/P220 Switch Operation Guide