Modifying Rip Interfaces - Lucent Technologies Cajun P220 Operation Manual

Configuring the RIP Routing Protocol (Layer 3)
Parameter
Purge TTL
Triggered Updates
Update Pkt Delay
3. Click APPLY to save your changes, or CANCEL to restore previous settings.

Modifying RIP Interfaces

To modify the RIP interfaces:
1. In the RIP Configuration section of the Web Agent window, click Interfaces.
The RIP Interfaces dialog box opens.
2. Use Table 8-2 to modify RIP interfaces:
Parameter
Select
Interface
Network Address
Mode
Send Version
8-2
Table 8-1. RIP Global Configuration Parameters (Continued)
Allows you to...
Specify the global Time To Live (TTL) in seconds that the RIP
update persists. The default value is 120 seconds.
Enable or disable route updates that were triggered by a
topology change in the network to be added to the routing
table. The default is Enable.
Specify the value (in seconds) that represents the time delay
between successive RIP update packets to the neighbor, when
the update requires multiple packets. The default value is 0
seconds (no delay).
Table 8-2. RIP Interface Parameters
Allows you to...
Select the RIP interface to be modified.
Displays an interface from a list of interfaces that you
previously configured.
Displays an IP address to be associated with the displayed
interface.
Specify the RIP State. Different states include:
• talk only (send RIP information to the network)
• listen only (receive RIP information from the network)
• talk/listen (both send and receive RIP information from
the network)
Specify the version of RIP you want to use to send packets
across your interface. Selections include:
• V1
• V2
• V1/V2
Cajun P550/P220 Switch Operation Guide