Configuring Ipx Interfaces - Lucent Technologies Cajun P220 Operation Manual

Configuring IPX Routing (Layer 3)
2. Use Table 4-2 to configure your global setup:
Parameter
IPX Routing
Use Default Route
RIP
SAP
Maximum Number of
Routes
Maximum Number of
Services
3. Click APPLY to save your changes, or CANCEL to restore previous settings and
close the dialog box.

Configuring IPX Interfaces

You can create new IPX interfaces and associate up to four interfaces of different
encapsulation types to a VLAN. The concept of more than one IPX interface on a VLAN is
referred to as multinetting.
To create a new IPX interface:
1. From the IPX Configuration section of the Web Agent window, click Interfaces.
The IPX Interfaces dialog box opens.
2. Click CREATE. The Add IPX Interface dialog box opens.
3. From the VLAN pull-down menu, select the VLAN to which you want to assign
an IPX network address.
Note: If you need to create a new VLAN, refer to "Creating and Implementing
4-4
Table 4-2. IPX Global Parameters
Allows you to...
Enable or disable IPX routing on a global basis. The default value is
Enable.
Enable or disable the default route, if known. The default value is
Disable.
Enable or disable IPX RIP on a global basis. This affects all IPX
interfaces set up to use the IPX RIP routing protocol. The default
value is Enable.
Enable or disable IPX SAP on a global basis. This affects all IPX
interfaces set up to use the IPX SAP routing protocol. The default
value is Enable.
Specify the maximum number of routes that can be added to the
routing table. The system rounds up your entry to the nearest
power of 2. For example, if you enter 1000, the system rounds this
number up to 1024 routes. The default value is 2048.
Specify the maximum number of services that can be added. The
system rounds up your entry to the nearest power of 2. For
example, if you enter 1000, the system rounds this number up to
1024 services. The default value is 2048.
VLANs" in Chapter 10.
Cajun P550/P220 Switch Operation Guide