Chapter 8 - Configuring The Rip Routing Protocol (Layer 3); Overview; Configuring The Switch Using The Rip Routing Protocol; Configuring Rip For The Switch - Lucent Technologies Cajun P220 Operation Manual

8
Configuring the RIP Routing
Protocol (Layer 3)

Overview

This chapter and its procedures are specific to Layer 3 configuration.

Configuring the Switch Using the RIP Routing Protocol

This section describes:

Configuring RIP for the Switch

Modifying RIP Interfaces
Creating Trusted RIP Neighbors
Interpreting RIP Statistics
Configuring RIP for the Switch
To configure the RIP routing protocol globally on your switch:
Note: You must enable RIP globally. To enable RIP, refer to "Configuring IP
Interfaces", and "Configuring VRRP", in Chapter 7.
1. In the RIP Configuration section of the Web Agent window, click Global
Configuration. The RIP Global Configuration dialog box opens.
2. Use Table 8-1 to configure the global setup:
Parameter
Global RIP
Update Timer
Cajun P550/P220 Switch Operation Guide
Table 8-1. RIP Global Configuration Parameters
Allows you to...
Enable or disable the RIP protocol. The default is Enable.
Specify the value (in seconds) that represents the time between
RIP updates on all interfaces. The default value is 30 seconds.
8-1