Configuring Non-Vlan Switch Port Parameters - Lucent Technologies Cajun P220 Operation Manual

8. Use Table 3-10 to configure your switch VTP Snooping parameters.
Parameter
VTP Snooping State
Domain Name
Configuration Revision Number
Updater Identity
Update Timestamp
9. Click APPLY to save your changes, or CANCEL to restore previous settings.

Configuring Non-VLAN Switch Port Parameters

To configure Non-VLAN switch port parameters:
1. In the Switch Port Configuration dialog box, from the Allow Learning
pull-down menu, select Disable to stop the port's learning of new addresses. This
feature can be useful for security. Selecting Enable allows the port to learn new
addresses.
For example, you can set this parameter to Disable, then add a static MAC address
entry for this port.
2. From the Hunt Group pull-down menu, select a hunt group for which this port
will be a member. Refer to "Using Hunt Groups to Aggregate Bandwidth between
Switches", in Chapter 12, for more information on hunt groups.
3. From the Spanning Tree pull-down menu, select to Enable or Disable spanning
tree protocol on this port.
Cajun P550/P220 Switch Operation Guide
Configuring the Cajun P550 Switch (Layer 2 & Layer 3)
Table 3-10. VTP Snooping Parameters
Definition
Select to enable or disable the VTP snooping protocol
globally for the switch. The default value is Disabled.
Enter the name associated with the Cisco VTP domain. The
default is Null.
Note:
The domain name is automatically learned
within approximately five minutes from a
Cisco VTP switch provided both the Domain
Name is Null and the VTP Snooping State is
enabled on the Cajun switch.
Displays the VTP snooping configuration revision number
associated with the last successful VTP configuration
update on the Cajun switch.
Displays the IP address of the Cisco switch that initiated the
configuration update.
Displays the date and time that the Cisco switch initiated
the configuration update.
3-19