Terminal Settings; Configuring The Supervisor Module Using The Cli - Lucent Technologies Cajun P220 Operation Manual

3
Configuring the Cajun P550
Switch (Layer 2 & Layer 3)
This chapter and its procedures are common to both Layer 2 and Layer 3 configuration.
Included in this chapter:

Terminal Settings

Configuring the Supervisor Module Using the CLI

Configuring the Switch Using the Web Agent
Configuring Port Parameters Using the Web Agent
Configuring System Information
Managing Configuration Files
Terminal Settings
To complete initial switch setup, you need a PC with a serial line connection. It must
have the following terminal settings to communicate with the switch (Table 3-1).
Baud Rate
9,600
Configuring the Supervisor Module Using the CLI
To connect to the Web Agent, you must first use the serial command line interface (CLI)
to give the supervisor module an IP address and a subnetwork mask.
Cajun P550/P220 Switch Operation Guide
Table 3-1. Terminal Settings
Stop Bits Data Bits
1 8
Flow
Parity
Control
Xon/Xoff None
3-1