Examining Dvmrp Interface Statistics - Lucent Technologies Cajun P220 Operation Manual

Examining DVMRP Interface Statistics

DVMRP interface statistics list active DVMRP interfaces and provide specific information
on each interface.
To examine DVMRP statistics:
1. In the DVMRP Display section of the Web Agent window, click Interface
Statistics. The DVMRP Interface Statistics dialog box opens.
2. Perform one of the following...
Click REFRESH to view the latest interface statistics.
Click CLEAR All to reset all statistics to zero.
Select one interface, and click CLEAR to reset the selected interface.
3. Use Table 7-20 to review the interface statistics:
Parameter
DVMRP Interface
Network Address
Address Mask
State
Type
Metric
IGMP Querier on
Interface
Next Probe Message in
(sec)
Cajun P550/P220 Switch Operation Guide
Table 7-20. DVMRP Interface Statistical Parameters
Defines the...
IP interface configured with the DVMRP multicast routing
protocol.
IP address of the interface configured with the DVMRP
multicast.
IP subnet mask associated with the interface.
Current status of the interface. Possible status indications
include:
• UP - The interface is active.
• DOWN - The interface is inactive.
Type of interface configured. Possible values include:
• Broadcast - All traffic is forwarded through the routers.
This is not a tunnel and does not require encapsulation.
• IPIP Tunnel - All multicast traffic (data and protocol
messages) on this interface is encapsulated in IP unicast
packets with the protocol set to IPIP (IP in IP).
• Non-Encapsulated Tunnel - All multicast data traffic on
this interface is IPIP encapsulated, but the protocol
messages are simple unicast.
Interface cost.
Router is the IGMP querier. The purpose of the IGMP querier is
to periodically poll hosts on your network to trigger group
membership reports.
Time (in seconds) remaining until the next probe message is
sent.
Configuring IP Routing (Layer 3)
7-33