Creating An Appletalk Routing Interface - Lucent Technologies Cajun P220 Operation Manual

Creating an AppleTalk Routing Interface

To create an AppleTalk interface:
1. Enable AppleTalk routing globally. Refer to "Enabling AppleTalk Global Routing",
earlier in this section.
2. In the AppleTalk Configuration section of the Web Agent window, click
Interfaces. The AppleTalk Interfaces dialog box opens.
3. Click CREATE. The Add AppleTalk Interfaces dialog box opens.
4. Use Table 10-1 to configure your AppleTalk interface.
Parameter
Interface
VLAN
Metric
Encapsulation Type
Network Range Start
Network Range End
Cajun P550/P220 Switch Operation Guide
Table 10-1. AppleTalk Interface Parameters
Definition
Enter the name of the AppleTalk interface to be created.
Select the VLAN to be associated with the AppleTalk
interface.
Options include:
• Default
• Discard
• All created VLANs
Enter the metric associated with the AppleTalk interface.
Select the encapsulation type to be associated with the
AppleTalk interface.
Options include:
• Ethernet II - MTU = 1500
• Ethernet SNAP - MTU =1492
Enter the starting network number. The network number
specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 0 and 65279.
Note:
The Network Range Start value must be less
than or equal to the Network Range End
value.
Enter the ending network number. The network number
specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 0 and 65279.
Note:
If the Network Range Start value equals 0,
Network Range End value must also equal
0.
Configuring AppleTalk Routing (Layer 3)
10-3