Creating Standard Access Rules - Lucent Technologies Cajun P220 Operation Manual

There is an implied implicit permit all at the end of the list. Also, you can only have
one list active at a time.

Creating Standard Access Rules

To create standard access rules:
1. In the IP Configuration section of the Web Agent window, click Access Lists.
The IP Access List dialog box opens.
Note: The IP Access List dialog box displays all standard and extended access rules
2. Click Create Standard. Valid numeric values are 1-99.
3. Use Table 7-4 to configure your IP access rules to either filter or prioritize traffic:
Parameter
Access List Name
Access Rule Index
Access Type
Source Subnet
4. Click CREATE to save your changes, or CANCEL to restore previous settings.
Cajun P550/P220 Switch Operation Guide
that have been created. If no rules have been created, the following
statement displays: No IP Access Rules are currently
configured.
Table 7-4. IP Access List Setup Parameters
Allows you to specify...
The alphanumeric name assigned to the newly-created access
list.
The sequence number for each new rule you create. Note that
rules may override each other, so review your current
configuration prior to creating new rules for an access list.
The method of handling incoming datagrams based on the IP
access type. Priority levels include:
• Deny/Filter - Allows you to filter out traffic based on the
specified configuration.
• Permit/Fwd pri8 (high) to pri1 (low) - Allows you to
prioritize traffic based on the specified configuration.
• Permit/Fwd with no change in priority - Allows you to
forward traffic with no change in priority.
• Source Address - The IP address of a subnet that is denied
or granted access to the switch.
• Source Address Wildcard - A range of IP addresses that
are denied or granted access to the switch. Place the
number one (1) in the bit positions you want to ignore.
Configuring IP Routing (Layer 3)
7-9