Notes About This Documentation; Validity Of This Documentation; Copyright - WAGO 8FDI 24V PROFIsafe 750-662/000-004 Manual

WAGO I/O System
750-662/000-004 8FDI 24V PROFIsafe
1

Notes about this Documentation

Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
Technical Terms in this Documentation
The technical terms used in this documentation are available in the glossary at
the end of the manual.
1.1

Validity of this Documentation

This documentation applies to: "8FDI 24V PROFIsafe" (750-662/000-004).
This documentation is only applicable from HW/SW Version 01/01.
The I/O module 750-662/000-004 shall only be installed and operated according
to the instructions in this manual and in the manual for the used fieldbus coupler
or controller.
Consider power layout of the WAGO I/O System 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler or controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2

Copyright

This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
written consent of WAGO GmbH & Co. KG, Minden, Germany. Non-observance
will involve the right to assert damage claims.
Notes about this Documentation
Version 1.0.0, valid from HW/SW Version 01/01
7
Manual